Chase Bliss Condor — MIDI Editor & CC Reference

Control the Chase Bliss Condor from your browser — MIDI control reference, interactive editor, and AI-generated presets. Free, no install.

Explore the Condor controls in your browser and connect compatible MIDI hardware to send settings to your pedal. The reference below shows the controls mapped in Nitelite; available functions depend on the pedal and firmware. The default MIDI channel in Nitelite is 2. Browser MIDI control works in Chrome, Edge, Opera, or Brave — no install required.

Knobs

Control	MIDI CC	Description
GAIN	CC 14	Gain up to 20dB. Controls ramp time when ramping is engaged.
FREQ	CC 15	Parametric mids frequency: ~150Hz (CCW) to ~4kHz (CW). Noon = ~1250Hz.
VOLUME	CC 16	Output level with internal voltage doubler for boost/headroom
BASS	CC 17	Bass boost (CW) or cut (CCW) up to 12dB. Noon = flat.
MIDS	CC 18	Parametric mids boost (CW) or cut (CCW) up to 18dB at FREQ frequency. Noon = flat.
LPF	CC 19	Low pass filter cutoff. Fully CW = open. CCW removes high frequencies.

Switches

Switch	MIDI CC	Positions
BASS	CC 21	SMALL / MOD / BIG
MIDS Q	CC 22	WIDE / FOCUS / NARROW
LPF TYPE	CC 23	1-POLE / 2-POLE / 2P RES

DIP Switches — CONTROL

Control	MIDI CC	Description
FREQ	CC 61	Enable ramping/expression control for FREQ knob
VOLUME	CC 62	Enable ramping/expression control for VOLUME knob
BASS	CC 63	Enable ramping/expression control for BASS knob
MIDS	CC 64	Enable ramping/expression control for MIDS knob
LPF	CC 65	Enable ramping/expression control for LPF knob
BOUNCE	CC 66	Bounce mode: parameters modulate back and forth
SWEEP	CC 67	Sweep direction: Top (T) or Bottom (B)
BUFFER	CC 68	Buffered bypass (on) or true bypass (off)

DIP Switches — CUSTOMIZE

Control	MIDI CC	Description
FREQ	CC 71	Rise/fall direction for FREQ expression/ramping
VOLUME	CC 72	Rise/fall direction for VOLUME expression/ramping
BASS	CC 73	Rise/fall direction for BASS expression/ramping
MIDS	CC 74	Rise/fall direction for MIDS expression/ramping
LPF	CC 75	Rise/fall direction for LPF expression/ramping
MOTOBYP	CC 76	Momentary engage/bypass for the pedal
DRIVE	CC 77	Drive dip: D = left stomp switches drive, H = hold mode
RESET	CC 78	Reset dip for hold/ramp behavior: H = hold mode, R = reset mode

Footswitches

DRIVE — CC 103
BYPASS — CC 102

Special MIDI Functions

Expression — CC 100
Drive/Bypass State — CC 103. Sets the combined engage/bypass state for the pedal and drive circuit. 127 = pedal on + drive on. 85 = drive on, pedal bypassed. 45 = pedal on, drive bypassed. 0 = pedal off + drive off.

Hardware Presets

Condor has 122 hardware preset slots, recalled using MIDI Program Change. Saving requires an action on the pedal; follow the hardware preset manager instructions.