Control the Chase Bliss LOSSY from your browser — MIDI control reference, interactive editor, and AI-generated presets. Free, no install.
Explore the LOSSY controls in your browser and connect compatible MIDI hardware to send settings to your pedal. The reference below shows the controls mapped in Nitelite; available functions depend on the pedal and firmware. The default MIDI channel in Nitelite is 2. Browser MIDI control works in Chrome, Edge, Opera, or Brave — no install required.
Knobs
Control
MIDI CC
Description
FILTER
CC 14
Filter frequency control
GLOBAL
CC 15
Global effect intensity control
REVERB
CC 16
Reverb mix amount
FREQ
CC 17
Frequency control for filter and loss artifacts
SPEED
CC 18
Speed of loss processing / packet rate
LOSS
CC 19
Amount of digital degradation / data loss
Alt / Secondary Knob Functions
Control
MIDI CC
Description
GATE
CC 24
Gate threshold for the gate effect
FREEZER
CC 25
Freeze texture / freezer control
VERB DECAY
CC 26
Reverb decay time
LIMITER
CC 27
Limiter threshold level
AUTO GAIN
CC 28
Auto gain compensation amount
LOSS GAIN
CC 29
Loss section output gain
Switches
Switch
MIDI CC
Positions
SLOPE
CC 21
6dB / 24dB / 96dB
PACKETS
CC 22
REPEAT / CLEAN / LOSS
MODE
CC 23
INVERSE / STANDARD / JITTER
DIP Switches — CONTROL
Control
MIDI CC
Description
FILTER
CC 61
Enable ramping/expression control for FILTER knob
FREQ
CC 62
Enable ramping/expression control for FREQ knob
SPEED
CC 63
Enable ramping/expression control for SPEED knob
LOSS
CC 64
Enable ramping/expression control for LOSS knob
VERB
CC 65
Enable ramping/expression control for REVERB knob
BOUNCE
CC 66
Ramp mode (off, one-shot) vs Bounce mode (on, continuous LFO)
SWEEP
CC 67
Sweep direction: Bottom (B, knob=min) or Top (T, knob=max)
POLARITY
CC 68
Ramp polarity: Forward (F) or Reverse (R)
DIP Switches — CUSTOMIZE
Control
MIDI CC
Description
MISO
CC 71
Mono In, Stereo Out - splits mono input to stereo output
SPREAD
CC 72
Engages stereo spread processing
TRAILS
CC 73
Wet signal fades out after bypass instead of cutting off
ALL WET
CC 74
Removes dry signal from output for parallel setups
PRE/POST
CC 75
Pre/Post reverb routing
SLOW
CC 76
Slow mode
INVERT
CC 77
Invert the loss pattern
LATCH
CC 78
Changes hold functions from momentary to latching
Footswitches
FREEZE — CC 103, hold: CC 105
BYPASS — CC 102, hold: CC 106
Special MIDI Functions
Tap Tempo — CC 93
Expression — CC 100
Ramp/Bounce — CC 52. Enables or disables the ramp/bounce (LFO) function globally.
Dry Kill — CC 57. Removes the dry signal from the output for use in parallel effects loops.
Ramp Speed — CC 20. Controls the speed of the ramp/LFO when ramping is enabled via the CONTROL DIP switches.
Weighting — CC 33. Tonal weighting of the effect: Dark (0–1), Neutral (2), or Bright (3+).
Factory Reset — CC 56. Resets all presets and settings to factory defaults. This cannot be undone.
Hardware Presets
LOSSY has 122 hardware preset slots, recalled using MIDI Program Change. Nitelite supports saving to hardware over MIDI.