Chase Bliss LOST + FOUND — MIDI Editor & CC Reference
Control the Chase Bliss LOST + FOUND from your browser — MIDI control reference, interactive editor, and AI-generated presets. Free, no install.
Explore the LOST + FOUND controls in your browser and connect compatible MIDI hardware to send settings to your pedal. The reference below shows the controls mapped in Nitelite; available functions depend on the pedal and firmware. The default MIDI channel in Nitelite is 2. Browser MIDI control works in Chrome, Edge, Opera, or Brave — no install required.
Knobs
Control
MIDI CC
Description
TIME
CC 14
Left channel time/rate
MIX
CC 15
Wet/dry mix (becomes RAMP SPEED when ramping active)
TIME
CC 16
Right channel time/rate
MODIFY
CC 17
Left channel modify + A/B variant selection
BLEND
CC 18
Left/right channel blend
MODIFY
CC 19
Right channel modify + A/B variant selection
Alt / Secondary Knob Functions
Control
MIDI CC
Description
ALT
CC 24
Left channel alternate parameter (varies by effect)
SPILL
CC 25
Cross-channel bleed amount
ALT
CC 26
Right channel alternate parameter (varies by effect)
EQ
CC 27
Left channel EQ/tone
GLUE
CC 28
Adds compression/saturation between channels
EQ
CC 29
Right channel EQ/tone
Switches
Switch
MIDI CC
Positions
Resonator voicing
CC 33
Hybrid / Clean / Clipped
L MODE
CC 21
1 / 2 / 3
ROUTING
CC 22
L→R / L+R / L←R
R MODE
CC 23
4 / 5 / 6
DIP Switches — CONTROL
Control
MIDI CC
Description
L TIME
CC 61
Enable ramping for Left TIME knob
L MODIFY
CC 62
Enable ramping for Left MODIFY knob
BLEND
CC 63
Enable ramping for BLEND knob
R MODIFY
CC 64
Enable ramping for Right MODIFY knob
R TIME
CC 65
Enable ramping for Right TIME knob
BOUNCE
CC 66
RAMP (off) vs BOUNCE ping-pong (on)
SWEEP
CC 67
Ramp starts at BOTTOM (off) or TOP (on)
POLARITY
CC 68
Ramp direction: FORWARD (off) or REVERSE (on)
DIP Switches — CUSTOMIZE
Control
MIDI CC
Description
MISO
CC 71
Mono In, Stereo Out - splits mono input to stereo
SPREAD
CC 72
Enable stereo spread processing
LATCH
CC 73
Footswitch holds latch instead of momentary
L SWAP
CC 74
Left channel borrows modes from right (enables combos)
R SWAP
CC 75
Right channel borrows modes from left (enables combos)
UNSYNC
CC 76
Unsync L/R tempos, free the TIME knobs
TRAILS
CC 77
Effects fade naturally after bypass
BANK
CC 78
Access on-pedal presets 3-4 instead of 1-2
Footswitches
L — CC 103, hold: CC 105
R — CC 102, hold: CC 106
Special MIDI Functions
Tap Tempo — CC 93
MIDI Clock Sync — CC 51. When on, the pedal follows incoming MIDI clock for tempo. When off, MIDI clock is ignored.
Dry Kill — CC 57. When on, the dry signal is removed and only the wet effect signal passes through.
ALT Menu — CC 104. Enters or exits the ALT menu (equivalent to holding both footswitches on the pedal).
Ramp Speed — CC 20. Controls the speed of the ramp/bounce modulation when ramping is active.
Master Wet Volume — CC 30. Controls the overall output level of the wet (effect) signal.
Spread — CC 32. Sets which channels receive the spread effect: L only (0–1), both (2), or R only (3+).
L Tap Subdivision — CC 53. Sets the tap tempo subdivision for the left channel (0=32nd, 6=quarter, 11=whole, 12=double whole).
R Tap Subdivision — CC 54. Sets the tap tempo subdivision for the right channel (0=32nd, 6=quarter, 11=whole, 12=double whole).
Factory Reset — CC 56. Erases all saved presets and restores the pedal to factory defaults.
Stop Ramping — CC 52. Immediately stops any active ramp or bounce movement.
Randomize L Mode — CC 112. Randomly selects a new effect mode for the left channel.
Randomize R Mode — CC 113. Randomly selects a new effect mode for the right channel.
Randomize Both Modes — CC 114. Randomly selects new effect modes for both left and right channels simultaneously.
Hardware Presets
LOST + FOUND has 122 hardware preset slots, recalled using MIDI Program Change. Nitelite supports saving to hardware over MIDI.