Chase Bliss Warped Vinyl HiFi — MIDI Editor & CC Reference

Control the Chase Bliss Warped Vinyl HiFi from your browser — MIDI control reference, interactive editor, and AI-generated presets. Free, no install.

Explore the Warped Vinyl HiFi controls in your browser and connect compatible MIDI hardware to send settings to your pedal. The reference below shows the controls mapped in Nitelite; available functions depend on the pedal and firmware. The default MIDI channel in Nitelite is 6. Browser MIDI control works in Chrome, Edge, Opera, or Brave — no install required.

Knobs

Control	MIDI CC	Description
TONE	CC 14	Wet signal tone. Noon = transparent. CW = cuts lows, CCW = cuts highs. Controls ramp speed when ramping engaged.
LAG	CC 15	Delay between wet/dry signals. Higher = lusher chorus. Keep low for vibrato to avoid latency.
MIX	CC 16	Wet/dry balance. Full wet = vibrato, middle = chorus.
RPM	CC 17	Vibrato modulation rate. Overridden by tap tempo.
DEPTH	CC 18	Vibrato width/intensity. Clockwise for extreme pitch-bending.
WARP	CC 19	Waveform asymmetry / center point. CCW = quick up/slow down, CW = slow up/quick down, noon = symmetric.

Switches

Switch	MIDI CC	Positions
WAVE L	CC 21	SINE / TRI / SQR
TAP DIV	CC 21	1/2 / 1/4 / 1/8
WAVE R	CC 21	SQR / TRI / SINE

DIP Switches — RAMP/EXP

Control	MIDI CC	Description
LAG	CC 61	Enable ramping/expression control for LAG knob
MIX	CC 62	Enable ramping/expression control for MIX knob
RPM	CC 63	Enable ramping/expression control for RPM knob
DEPTH	CC 64	Enable ramping/expression control for DEPTH knob
WARP	CC 65	Enable ramping/expression control for WARP knob
BOUNCE	CC 66	Bounce: parameters modulate back and forth. Off: ramp and hold.
HOLD	CC 67	Hold mode for tap/hold stomp: - position deactivates LFO, + position activates LFO momentarily
MoToByp	CC 68	Momentary-to-bypass: pedal only active while bypass stomp is held

DIP Switches — DIRECTION

Control	MIDI CC	Description
LAG	CC 71	LAG ramp direction: rise (CW) or fall (CCW). Also controls expression behavior.
MIX	CC 72	MIX ramp direction: rise (CW) or fall (CCW)
RPM	CC 73	RPM ramp direction: rise (CW) or fall (CCW)
DEPTH	CC 74	DEPTH ramp direction: rise (CW) or fall (CCW)
WARP	CC 75	WARP ramp direction: rise (CW) or fall (CCW)
TAP CTRL	CC 76	R = tap sets ramp rate, P = tap sets RPM rate
TAP DIV	CC 77	Enables alternate tap division bank (3/6/8 instead of 1/2/4)
SWEEP	CC 78	Sweep direction for ramp/expression. T = knob to max, B = knob to min.

Footswitches

TAP/HOLD — CC 93
BYPASS — CC 102

Special MIDI Functions

Tap Tempo — CC 93
Expression — CC 100
MIDI Clock — CC 51. When ON, the pedal listens for MIDI Clock messages and syncs tempo. When OFF, MIDI Clock messages are ignored.
Ramp Speed — CC 20. Controls the speed of the ramp when ramping is engaged. Also controls the TONE knob speed during ramping.
MIDI Note Division — CC 21. Sets the tap tempo note division via MIDI. 0 = whole note, 1 = half note, 2 = quarter note triplet, 3 = quarter note, 4 = eighth note, 5 = sixteenth note.

Hardware Presets

Warped Vinyl HiFi has 122 hardware preset slots, recalled using MIDI Program Change. Saving requires an action on the pedal; follow the hardware preset manager instructions.